Sand Casting introduction PDF file will bring you more
technical contents.

Sand Casting



One of the major defects in sand casting is sand inclusion. Sand inclusion prediction using AnyCasting is intended to help the overall design change by grasping the location information of where sand drop may occur during pouring.

Sand Inclusion
  • Sand drop area prediction using mold erosion theory
  • Easily change the design to minimize defects
Sand Inclusion

Oxide & Slag

Oxide is one of the factors that can cause surface defects and various internal defects. It is caused by the formation of an oxide film when the melt is exposed to the air during filling. In addition, if the slag remains in the melt, it may move along the flow of the melt and become isolated within the product, causing defects. These inclusion predictions can provide a lot of information to the user in runner design and selection of the risers.

Oxide & Slag Prediction
  • Prediction of final retained areas and identification of inclusion paths during flow
  • Easy to verify soundness of runner and vent design
  • Easily verify the discharge system, which causes defects, such as installing risers in an appropriate location